BREAK-IN PROCEDURES

BREAK-IN PROCEDURES

When breaking in your new Dreadtec™ barrel, you should perform appropriate fire and clean cycles to normalize the bore surface. Each fire and clean cycle consists of a certain number of rounds fired (one to five) followed by a cleaning procedure (see below for reference), to be completed a certain number of times (1-25). These vary depending on the type of steel of the barrel, bore/groove diameter, velocity and pressure of any given round, etc. This is to be used as a guideline. Since our core barrels are hand-lapped, each barrel may break in a little differently. Some barrels may require more or less shots or cycles to break in than what is listed here.

416R Stainless Steel Cores: 

Fire one (1) round then clean - Perform 5-10 times 

Fire three (3) times then clean - Perform 1 time

Fire five (5) times then clean - Perform 1 time

Example: 

For a Dreadtec™ 416R Stainless Steel core barrel, you would fire one round, then perform the cleaning steps outlined below a total of five to ten times (shoot 1 round & clean, done 5-10 times) before starting the three shot cycle where you would fire three rounds and then clean as outlined below, then proceed to fire five rounds then clean, completing the break-in procedure.  Each Firing Cycle (1 shot, 3 shot or 5 shot) should be followed by cleaning the bore (see steps below for reference):

Cleaning:

1. Using a one-piece, coated cleaning rod with a properly sized bore brush (wet with your favorite non-foaming bore solvent), carefully clean the bore from the chamber end toward the muzzle (3-5 passes is usually sufficient). If you cannot clean from the chamber end, be sure to use a bore-guide so as not to damage the crown or muzzle end of the rifling. Let sit 30-60 seconds before moving on to the next step.

2. Push a dry patch down the bore. (2-3 times)

3. Put a few of drops of oil on a patch and push that down the bore so as to leave a thin film of oil inside the bore.

4. Begin a new cycle: Fire your next round or rounds in your next firing cycle and repeat cleaning as necessary.

It is recommended to keep a written log of your current step within the process so if you get distracted you will know where you left off.

WARNING: Cancer – www.P65Warnings.ca.gov

Contains:

Calcium carbonate (471-34-1), Phenol, polymer with formaldehyde, glycidyl ether (WM=700)
(28064-14-4), bis-[4-(2,3-epoxipropoxi) pheny]propane (1675-54-3), Terphenyl, hydrogenated (61788-32-7), [3-(2,3-epcoxypropoxy)propy] trimelthoxysilane (2530-83-8), Polyphenyls, quarter-and higher, partially hydrogenated (68956-74-1), carbon black, respirable powder (1333-86-4) Polythio Ether Polyether, Thiol Terminated (Not available), Calcium carbonate (471-34-1) ethyl acetate (141-78-6), aluminum hydroxide (21645-51-2), Formaldehyde, polymer with 3-chloro-1-propane and phenol (28470-78-2), titanium dioxide (13463-67-7)

Note: Two-part epoxy cured prior to shipment